1st swap

[dickwiley]

so this is what i did tonight started porting the heads takin the lump out.
WP_20130925_006.jpgWP_20130925_015.jpgWP_20130925_005.jpgWP_20130925_007.jpg

[dickwiley]

tonight I started takin dismantling the old motor, hopefully by tomorrow i can pull it out so i have the rest of the weekend to finish porting my heads. I borrowed my buddies power washer so i can clean up the engine bay to make it look a little better.

WP_20130926_004.jpg
WP_20130926_005.jpg
WP_20130926_006.jpg

[Mickeymotormount]

Looks like you're off to a good start. Good luck with the swap.

[dickwiley]

Yea just need a few other things mainly a yoke for my 4l80 I need a bolt counter bore. Other than that I'm pretty good. The part thats gonna take the longest is finishing the port and polish on my heads.

[dickwiley]

So I got a little done this weekend. Pulled old 350 tbi out, degreased the engine bay and painted it.

WP_20130926_006.jpg
WP_20130927_007.jpg
WP_20130928_003.jpg
WP_20130928_005.jpg
WP_20130928_007.jpg

[Mickeymotormount]

Might want to check your motor mount plates. Looks like you have them swapped. The pointed end/clamshell mounting faces forward.

[dickwiley]

lol alright Ill checkem again. I really wasnt sure.

[dickwiley]

got a little more done tonight not to much. got ls2 cam installed and lifters soakin in oil. soakin my second intake manifold so i can clean it up and smooth it out.
WP_20130930_014.jpg
WP_20130930_015.jpg
WP_20130930_013.jpg
WP_20130930_017.jpg

[dickwiley]

Been a Minute since ive posted in here. Had somethings happen, stopped me from workin but ive got a little more done since my last post. I finished the heads. I broke a bolt off on block so had to get that fixed. I put most of block together. Put Eaton posi in. Im working on harness now. Did a few other things.

WP_20131004_009.jpgWP_20131004_008.jpgWP_20131004_007.jpgWP_20131019_004.jpgWP_20131019_001.jpg

[dickwiley]

WP_20131020_001.jpgWP_20131024_009.jpgWP_20131021_004.jpgWP_20131023_005.jpgWP_20131024_007.jpg