ok so idk if you got it figured out. but like i said i was gonna confirm the wires and i did. all i had to change was the light green wire going to the reverse lights. everything else stays the same. BUT i am using the original harness, pcm, and fuse box. so our setups are a lil different. at this point im not sure if my gear indicator light will light up. i havnt checked that part out. i will try and confirm that in the next few days. but i just wanted to say that the round connector matched up perfect (no re-pinning), same for the 4 wire connector pnp, and same for 6 wire pnp with the exception of the reverse lights. like i said, just take the new gray wire and hook it to the old light green going to the lights and you should be good on that part. hope that helps. let me know