wheel speed sensor and brake booster delete

[farmtruc]

the pcm can run the efans based on coolant and a/c line pressure.

[jansen]

Not really concerned with reverse lights since the truck will see very little street time (race truck! Lol). All ac components have been removed except for the wiring. Any reason I can't use the 12v wire for the ac system to trigger a relay to turn the fans on when I press the ac button?

[farmtruc]

As long as the relay is fed the correct signal it'll work.

[George C]

my truck has no auto wiring in it anymore...need a few wires from harness and your good least in my case...a th400 you could techincally ditch it all then.....you can also get a hot rod harness

[jansen]

I should have unplugged the prndl switch and tried to start it before I removed half my engine from the truck. I'm just trying to make sure that if I delete all tranny wiring that my truck won't think its in gear and not spin over. I would like to just modify my harness since i already have it. Probably gonna ditch the 400 and put a glide in it. Can someone look at pin # 33 on this link and please elaborate. http://www.lt1swap.com/99-02_vortec_pcm.htm

[George C]

i posted on PT.net back in 07 about what wires needed to do what.. look for name quik in the T56 thread

I should have unplugged the prndl switch and tried to start it before I removed half my engine from the truck. I'm just trying to make sure that if I delete all tranny wiring that my truck won't think its in gear and not spin over. I would like to just modify my harness since i already have it. Probably gonna ditch the 400 and put a glide in it. Can someone look at pin # 33 on this link and please elaborate. http://www.lt1swap.com/99-02_vortec_pcm.htm

[jansen]

Thanks George! I'll do that!