Kevhill85 2dr Tahoe build

[kevhill85]

What are you going to gap them to?

per mahle
3.905 x .005
Top ..020
2nd .022

I am think of .022 and .024

[ChevyLee]

Are you not going to do any type of power adder like boost or spray?

[kevhill85]

Are you not going to do any type of power adder like boost or spray?

Spray a 150 to 200 shot two stage

[kevhill85]

Today i mocked up the DRods fuel cell into my 2dr Tahoe .. I pick this cell from TxStVanWilder Friday and it fit great.. Here what left to do so the fuel cell fit the way I need to ..

Cut about 2 3/4 off the back side of the mounting tab
Add some rubber cushion between the frame and cell mounting tabs.. Should lowwer the cell about 3/4 of an inch

[kevhill85]

Here where I am at on the motor rebuilded. For the stall I went with a revmaxx 2600 stall.. I figure use the lt 4l60e and a stall untill it blow and then go with a 4l80e

[kevhill85]

Ok finally had time to work on the Tahoe .

Cut the floor and made room for the drive shaft



Drilled and tapped the the head for a mech temp gauge.


You see in the next two photo how much the rear was narrowed .

[kevhill85]

Some new parts showed up today

[RPM Graphics]

nice!!! i need to get a couple of those Viair's, since i lost my engine driven.

[kevhill85]

Thank u
They are price fair too. I paid $220.00 for both 444c comps

[navi243]

any updates on this build?