truck is a 1997 c1500, motor is a 2002 lq4 stock fuel rails, #60 injectors, brand new single 255 walbro pump with hotwire kit, new fuel filter.
when i fire the truck up it only primes to 50 ish psi, it doesnt change much when its running, but when i get on the gas it drops to at the lowest 25 psi, i've looked everywhere and see no leaks on the adapters from my old line to the fuel rails. i did take the fuel pressure regulator out once to make sure it didnt have any trash in it. could the regulator be bad?
i'm thinking i am just going to pull the bed tomorrow to make sure that nothing is loose on top of the tank and that the rubber hose hasnt ruptured. i checked voltage on the pump and it seemed fine i'll check it again when i pull the bed, it should be at 12v or greater right?
any suggestions?