project "GoNDown"

[slicpartna]

hey RPM,


great write up on the build of the truck.
I really like the attention to detail

Did you do anymore work to the engine?

[RPM Graphics]

nothing done, just a stock LS1, CAI, LT's, & a tune. trying to get the doors finished & get my compressors hooked up. this little IS is starting to take my truck funds, LOL!!!
brakes are pretty bad so i just ordered some pads & i need a new stitch for the passenger seat.

[slicpartna]

hey RPM,

what motor mounts did you use?

thanks

[RPM Graphics]

i used a set from Wisner Machine Works in Michigan. he sells them on ebay. i bought the multi hole set, 1" back, center, 1" forward. i used the center holes & everything fit & lined up great. i used the trans from the camaro so i had to adjust my trans cross member, but other then that the Schoenfeld headers & everything fit great.

[slicpartna]

i used a set from Wisner Machine Works in Michigan. he sells them on ebay. i bought the multi hole set, 1" back, center, 1" forward. i used the center holes & everything fit & lined up great. i used the trans from the camaro so i had to adjust my trans cross member, but other then that the Schoenfeld headers & everything fit great.

cool, thanks for the info

[bradshow]

Sweet build and an awesome fint on the IS.

[RPM Graphics]

i haven't been doing too much on the truck since i bought the IS300. i did get both door handles in though. now to just finish them up & re-paint.



on a side note. i just found another LS1 from an 02 camaro i'm trying to scoop up. complete motor, trans, & harness for $600 with 40k on it.
crossing my fingers the guy will call me to come get it this week. possibly a 240 with an SR20 also. i'm hoping to pick up everything & flip the 240 & get the LS1 for free basicly.