r4 compressor mount

[exboatracer]

I agree with 1991ssp, just slice off 2mm or whatever it takes to make it fit.Have you looked into the alan grove brackets? Maybe one of his would work for you depending on which intake your using. I cant use anybodys brackets since i'm trying to run a car intake,truck accessories and a r-4 compressor. I'm using a v-6 compressor bracket and when you cut it all up,clean it and paint it it looks pretty good. Good luck.

[Slick68]

I just found that Holley has these setups that work with any car/truck system. Not sure about price though.

http://holley.com/types/LS%20Accessory%20Drives.asp

[exboatracer]

Good find!

[avilleg0]

i just bought dirtydingo bracket its pretty nice they had the part on hand and quick shipping very happy

[gagliano7]

I just found that Holley has these setups that work with any car/truck system. Not sure about price though.

http://holley.com/types/LS%20Accessory%20Drives.asp

I see Jegs has for $130 but it won't ship until Aug 3.I wish i knew this before i bought mine.It looks like a very nice easy setup.

http://www.jegs.com/i/Holley/510/20-133/10002/-1

[bow tie klr]

I see Jegs has for $130 but it won't ship until Aug 3.I wish i knew this before i bought mine.It looks like a very nice easy setup.

http://www.jegs.com/i/Holley/510/20-133/10002/-1

I ordered mine Tuesday from summit and it came in today. Looks nice. There is a little more to the kit that just that. You also have to get the spacer and tensioner. There are three spacers depending on if you are running fbody, truck or vette accessories. I am gonna get it installed this weekend hopefully and see how it fits. It looks nice so far.

[gta87305]

can the factory air ducting from the gen 3 truck engines be used with any of these brackets? I have a new r4 compressor and also want to use the factory duct and airbox from the nbs truck. Thanks