some notes from a beginner, change rings or change pistons?

[Chevy-Art]

Where did you buy the intake, can you return it?

[DBRODS]

Did you measure the clearance on the rods? Those mains are super tight..

[sand man]

I used the wrong plasitgauge , i was supposed to use the GREEN not the red

i JB welded the the intake manifold for now , will buy somthing better than stock , considering the stock bare manifold is for 258$

[sand man]

ITS ALIVE
started the truck yestrday ,it was in a coma for 6 weeks !!

drives good just dies when slowing down under 12-15mph to turn or stop at a light.

needs a retune

as for any thing else i noticed some good torque gains on idle to 3000rpm with part throttle ,cant step on it just yet , breaking in the new bearings/piston rings

every thing else is great

will try to post some pics

[sand man]

sorry for droping this thread, I had so much going on on the same time, getting the motor in te truck, preparing myself and my brother for a trip to Czech Repuplic for pyshical therapy, and having exams too.

So, im in Czech now , here are the last pics i took of the truck

please dont trash me on the garage I work in, this was the only place i had availlabe for free.










only had these pics when i was greasy , i gave my cuz the cam, the lazy basterd only took 4 pics , I KILL HIM:fume:

start up vid is in the cam

[Givint41]

sorry for droping this thread, I had so much going on on the same time, getting the motor in te truck, preparing myself and my brother for a trip to Czech Repuplic for pyshical therapy, and having exams too.

So, im in Czech now , here are the last pics i took of the truck

please dont trash me on the garage I work in, this was the only place i had availlabe for free.










only had these pics when i was greasy , i gave my cuz the cam, the lazy basterd only took 4 pics , I KILL HIM:fume:

start up vid is in the cam

well keep updating here. will look on through it especially when the project outcome comes. what would be the looks?



http://www.niceledlights.com

[sand man]

Im n czech now, cant realy take pics or vids , havet tuned it yet, the A/F ratio is way rich , it hits 9.5:1 to 9:1 on WOT and it smokes like a diesel its running on the 5.3/cam ECM/tune . the 6.0 ECM is set up on 4L80 and no electric fans so cant really use it.

ill be back in a month or so, ill dyno tune it then hoping to get 390-400 , the 5.3 did 365/368 with this cam