6.0 build

[low2001gmc]

good info. thanx guys. i got an lq9 i want to throw some ls3 heads along with a pat g 223-231, 610-617, 113+4 cam. CONCERN: LQ9 RINGLAND ISSUES IVE BEEN HEARING ABOUT.

i also would like to mill heads .015 and use a .040 gasket to raise compression. CONCERN: PTV WITH ABOVE CAM. would a cam with same specs but on a 112 provide better PTV??? (Buddy has one and I could try trading

any input would be appreciated guys, Rob

[skeet]

good info. thanx guys. i got an lq9 i want to throw some ls3 heads along with a pat g 223-231, 610-617, 113+4 cam. CONCERN: LQ9 RINGLAND ISSUES IVE BEEN HEARING ABOUT.

i also would like to mill heads .015 and use a .040 gasket to raise compression. CONCERN: PTV WITH ABOVE CAM. would a cam with same specs but on a 112 provide better PTV??? (Buddy has one and I could try trading

any input would be appreciated guys, Rob

never heard of a ringland issue unless i missed it? well i never had issues, cam is fine with those heads as far as PTV goes even milled, but its always nice to check.