Speedway Part Numbers:
Part Number # 182-2277 12m to 3/8 Npt Water Temp.
Part Number # 182-2268 16m to 1/8 Npt Oil Pressure
Speedway Part Numbers:
Part Number # 182-2277 12m to 3/8 Npt Water Temp.
Part Number # 182-2268 16m to 1/8 Npt Oil Pressure
Wanted to update everyone with what I did. Since the hole on the motor is 16 mm MALE, and my OBS sensor is 3/8 male ( that screws into female) the part i bought from speedwaymotors was wrong because it was 16mm male x 1/8 female...so what i did was went to napa and got a 1/8 male to 3/8 female adapter for 4 bucks. worked great. so i basically have 2 adapters on top of eachother and then my sensor, but it works and i can have the sensor so its sticking straight up so its easy to tighten (unlike when its on a 90 degree angle and it hits the firewall when i tighten it)
Silverado Z71 10" Lift COMPLETE 6.0/4L80E PRC 2.5 Ported LS6 Heads 228r Comp Cam 3200 CIRCLE D Stall LS7 Lifters ARP Bolts SLP Oil Pump and Double Timing Chain 160 T-Stat 3" SLP Loudmouth Electric Cutout Walbro 255 Pacesetter Longtubes MSD Starter NELSON Harmess NELSON Street/Strip Tuned ECM MSD Wires LS1 Throttle Body Braided Lines Spectre CAI 4.56 Gears Detroit Locker 14 bolt http://www.ls1truck.com/forums/lsx-t...wap-build.html
Does anyone have good pics of these installed? Are you using an existing hole or tapping new? Where?
I used the hole right on the back edge of the block.Originally Posted by Wagonbacker9
Silverado Z71 10" Lift COMPLETE 6.0/4L80E PRC 2.5 Ported LS6 Heads 228r Comp Cam 3200 CIRCLE D Stall LS7 Lifters ARP Bolts SLP Oil Pump and Double Timing Chain 160 T-Stat 3" SLP Loudmouth Electric Cutout Walbro 255 Pacesetter Longtubes MSD Starter NELSON Harmess NELSON Street/Strip Tuned ECM MSD Wires LS1 Throttle Body Braided Lines Spectre CAI 4.56 Gears Detroit Locker 14 bolt http://www.ls1truck.com/forums/lsx-t...wap-build.html
Posting Permissions
Reply With Quote