94 Lifted Silverado 6.0/4L80e swap Build

[92 6.0]

Sorry I can't help with the line fittings. But I bought an adapter of ebay the goes on the side of the oil pan for the oil pressure for like $10 and tapped the waterpump for the temp sensor. You could just get the thre wire sensor for the ls1 fbodys for the temp sensor.

[Teck]

Here is a few pic of my tranny lines done in AN^ Stainless Steel braided lines with a remote filter and cooler.I can looks up the fittings I used on the tranny (think they are 3/8 to AN6 but not 100% sure) and the ones at the radiator( i think where fuel/carb fitting to AN6
IMG_1229.jpg
IMG_1232.jpg
IMG_1270.jpg

[HPICamaroSS]

[QUOTE=Teck;471210]Here is a few pic of my tranny lines done in AN^ Stainless Steel braided lines with a remote filter and cooler.I can looks up the fittings I used on the tranny (think they are 3/8 to AN6 but not 100% sure) and the ones at the radiator( i think where fuel/carb fitting to AN6

Ya my rubber hose running into my trans cooler is 3/8. I did get all my fittings today from summit, what I ended up doing was getting a -6 AN to 3/8 hose barb and ill just connect the rubber lines to my braided lines. Im still unsure of the right fittings that screw into the actual 4l80e case though. The part number from summit is #640520.....http://www.summitracing.com/parts/RUS-640520/ but they just dont look right. they seem to small. I don't know maybe im wrong, once i get a chance to get out to the barn ill try putting them in. Is your tranny 4l80e? And if you can, that would be great if you could look up the fittings you used in your case.