Brand new gears trashed?

[skeet]

now dont get me wrong parts do fail, nothing is perfect a good picture of the wear pattern will identify the issues or issue at hand

[CHEVROLADE]

that sux post pics of ring/pinion if u get em out soon

[phantom405]

I'm going to go with ring gear bolts backed out

[qwk_snd]

I'm going to go with ring gear bolts backed out

that definitely is a possibility... didn't think about that.

[J Industries]

Hope it all works out, but I dont think you would get him to buy you a new R&P.

You brought him parts that he didnt make a dime on, so warranty wont carry over.
It would be like bringing your own eggs and toast to dennys, if it sucked they wouldnt refund you.

I would check the ring bolts, and pinion nut, or better yet have him do it. If the wear mark is off then its his bad and his fault. If something straight broke then its up in the air.

[qwk_snd]

Hope it all works out, but I dont think you would get him to buy you a new R&P.

You brought him parts that he didnt make a dime on, so warranty wont carry over.
It would be like bringing your own eggs and toast to dennys, if it sucked they wouldnt refund you.

I would check the ring bolts, and pinion nut, or better yet have him do it. If the wear mark is off then its his bad and his fault. If something straight broke then its up in the air.

Yeah, definitely, but I'm almost positive it has everything to do with his install. Like I said, I don't know ANYTHING about setting up rear-ends, but all I remember him checking was the pattern with the yellow paint stuff, and something that measured out .08? But that's it... Isn't there more?