Kevhill85 2dr Tahoe build

[kevhill85]

My plans
1) 4link truck so I can keep back seat
2) install ls1 383 stroker / 4l60e
3) redone the to all black
4) remove all bags
5) make it more a prostreet truck
6) coil over the rear
7) install a 6lug 10bolt narrowed 3inch
8) whatever else I can think of
9) complete frame made of 2x4 1/4 wall . We added the rear clip to the new frame so I can still run a rear bumper .
10) set of 317 heads milled .030





Updated photo's right here
http://photobucket.com/albums/q169/k...ahoe prostreet

I took a few photos today. I hope to have this thing home this weekend.






Well the tahoe home and now the work can start!!!!






Well I picked up some front end parts today.. Spindles,springs,lower control arm bushings, up and lower ball joints...


Crapy pic but somewhat show how much of the floor was removed. iPad dose not take good pic inside


Cleaned and painted the front clip. the white spot is soap.


Ok guys took some pic in the day light. Hope to have the motor and trany in today.

[kevhill85]

Ok time for update and photos .. I hope to order the ls1 383 stroker kit next week..


New mounts /// Dirty Dingo

5.3 ls1 block borded out to a 3.905
New cam bearing install



Order a PSI wiring harness.. Very nice piece of work

All so bought a 3 inch narrowed rear end from a 2006 chevy truck

started to Install the 4 link

Schoenfeld headers

317 heads milled .030

[Chris@LSXPS]

I love 2dr tahoes. sub'd!

[kevhill85]

I love 2dr tahoes. sub'd!

Thank you. I have been looking for a good deal for on a 2dr 2wd tahoes. My buddy started this build and decided to move on to a new project. I got a sweet deal on this one.. I have to z the core support area so the front lip can be installed..

[RPM Graphics]

nice progress. is that mike's upper control arms from dallas hotrod parts?

[kevhill85]

nice progress. is that mike's upper control arms from dallas hotrod parts?

Yes, I believe they were the first set he made..

[kevhill85]

Man, I did not think this swap was going to be this expense at frist .. But I can see the light at the end of the tunnel ...

What would be a good injectors for a ls1 383 stroker ???
Hope to order the fat intake next week as well.

[RPM Graphics]

yeah, things start to add up quick & one thing usually leads to another.

[kevhill85]

I was checking out lt1swp to see if I need to buy a new PCM but I am not sure still. Ok here is what I am try to figure out.

I have a blue / Green PCM that lt1swap shows it can be use with a DBC.. Has anyone use the green/blue PCM I place of the red/blue PCM?
photo of my PCM tag?.. Can this PCM be tuned for DBC?

[Chris@LSXPS]

red/blue = DBC
green/blue = DBW

i have a couple red/blues at my shop. i might be interested in trading you for yours