Well i just got my 6.0 tuned for 13 pounds and runs great!! But last night i was gettin on it and it hit the rev limiter going into 3rd. I let off a little and let it shift, then when i was turning i heard a knock. i took it easy home and its knockin pretty good. Just wondering what it might be. Should i start looking for another 6.0??
02 Z71-5.3/4l80e-P.I.2800-TR220-Ported heads-Pacesetter LT-Auburn E-locker-E Fans-42lb. injectors-RWHP 301-RWT 305
could u get some vid of it?hows oil pressure?
I think you took out your trans. Exact same thing happened to me from the 2-3 miss shift all the way to the knock.
its shifts fine, and i just pulled valve covers and no broken valve springs,i find it hard to believe i screwed up the lower end...
02 Z71-5.3/4l80e-P.I.2800-TR220-Ported heads-Pacesetter LT-Auburn E-locker-E Fans-42lb. injectors-RWHP 301-RWT 305
Go make a wot 2-3 shift pull again and see what happens. Why would it miss 3rd unless it's not pressurin up? Could be in the tune I guess or you took out the pump.
Last edited by EmmerichLSx; 08-11-2011 at 06:37 PM.
Any update on this?
If you have drive by cable, your tp sensor was reading wrong, mine dud that before, the knock I am not sure of? Maybe a bent valve or spun bearing,
http://www.youtube.com/watch?v=8Rfua...eature=related
My truck sounds just like this guys motor. Oil pressure is normal,and i changed all the pushrods with another set i had laying around and still knockin. Whats this video sound like?
02 Z71-5.3/4l80e-P.I.2800-TR220-Ported heads-Pacesetter LT-Auburn E-locker-E Fans-42lb. injectors-RWHP 301-RWT 305
dead lifter in the vid!
Simple: 408 on steroids!
single digits coming soon!
Spun rod bearing?
Posting Permissions
Reply With Quote