OBS LS1/6 headers

[NITROUS]

I can see where some type of mod has been made to the #2 and #6 tubes. They are bent higher up it looks like but that could be an optical illusion. The thicker 5/8" motor mount adapters give you a little more clearance at on the rear control arm eccentric. There have been so many issues with this problem wonder if they went on ahead and made a slight bend in these areas? They look awsome bro!!! What kind of wires did you use?

[NITROUS]

<div class='quotetop'>QUOTE(NITROUS &#064; Feb 11 2006, 03&#58;08 PM) [snapback]44225[/snapback]</div>

I can see where some type of mod has been made to the #2 and #6 tubes. They are bent higher up it looks like but that could be an optical illusion. The thicker 5/8" motor mount adapters give you a little more clearance at on the rear control arm eccentric. There have been so many issues with this problem wonder if they went on ahead and made a slight bend in these areas? They look awsome bro&#33;&#33;&#33; What kind of wires did you use?
[/b]

My point exactly&#33; I wonder when they made the change motoxlifer? Hey what are the part numbers form S&P on your headers and vettetruck&#39;s? Maybe we need to compare since there is more than one type III header.

BTW, How many miles do you have on them? They look great&#33;

His adapters look right to me. They look just like mine but thicker.

Hey moto, I just noticed your motor is about and inch further up than ours.

moto, did you have to mod the frame or anything on the passenger side for the altenator with the engine sitting that far up?

This is the kind of technical differences I like to compare on installs. We might all learn something here. you can see where my adapters sit.