Josh Power's AC bracket

[DRAGGIN95]

Mine is notched the same.

[pacobeagle]

I have a question, have all of you relocated the intake tube towards the driver side as pictured above? Also, what is the cost of this kit. I'm almost done with my 4.8l swap and I'm not liking the idea of 100degree days w/o a/c.

[RPM Graphics]

i'll be getting mine from Josh. here's a link to the site.
http://www.customimagecorvettes.com/...ries/LSx-Swap/

[silverado_lover]

I need to buy these already but how the hell do I check out!?

[93ND500]

I have a question, have all of you relocated the intake tube towards the driver side as pictured above? Also, what is the cost of this kit. I'm almost done with my 4.8l swap and I'm not liking the idea of 100degree days w/o a/c.

No kit was avalable when I did it. I just used some big truck exhaust and made my own. Cost about $40 for the pipe and a few extra for some paint. The rubber boot I got form Pepboys.

[silverado_lover]

Did anybody's stock A/C lines hook up?

[dustiebutt]

I am in the process of setting up the A/C with the brackets and found my stock '93 A/C lines are way too long and the hard lines out of the compressor actually head in the wrong direction....need to find an alternative for the stock lines....the line going to the condensor will be OK but the line going to the drier needs to be way shorter......not sure if there is a stock application from another vehicle that will bolt right up to the back of the stock compressor.............anybody have the same problem??

[jakedewey]

my buddy is using the ac bracket from dirty dingo on his 92 with a 6.0 swap. It allows you to use the factory air compressor

[dustiebutt]

the A/C brackets tha Powers makes does allow you to use the stock OEM compressor

my buddy is using the ac bracket from dirty dingo on his 92 with a 6.0 swap. It allows you to use the factory air compressor