Freshly done 862 heads-- ported/polished/milled

[Frenchy]

You do realize these are more expensive than a set of PRC's or Patriot's right? Like I have $1150 in my Patriot LS6's, that's including being worked over again by hand, new valves and dual Patriot Extreme springs.

[oleshifty]

I realize that. At the time I got these, the PRCs and Patriots were a bit more money and most have a much higher compression ratio, which is why I went this route. These are a better option for guys trying to stay N/A. 243 based heads were just too low compression for what I was trying to do.

I'm open to offers, just figured I would start at what I had into them, especially since shops around here wanted around 1000 just for the machine work these have done. That doesn't include springs/valves/heads themselves. I'm sure there are heads for sale cheaper then these, and there are surely heads going for much more. Lambo has been down some pretty decent numbers with relatively small mods, so I'm assuming these heads flow pretty well.

[Botlfed]

Glwts, theyve been worked more than my heads i know that, you should try to find a flow bench and get the numbers, might help with the sale....idk

[oleshifty]

1250?

[oleshifty]

1k...need these gone asap, make offer if you're interested

[oleshifty]

ttt

[skeet]

whats the lift on the springs? what brand valves? pics of port work on intake and exhaust side?

were you installing these on a 5.3 or 6.0