launching hard, safely, requires?

[TurboMic]

The cause of the pull right or left with the 4wd launch is usually having the torsion bars cranked up and having a steep cv angle. With a nice level cb angle, it will pull fairly straight. And most half tons launching are lowered and have a good cv angle. Even on my dmax, I'd drop the torsion bars all the way down, and was 100% better than with it even at stock level. Hope this helps. Good luck

[2boosted]

Mic is right on the money !!!!

I have a 08 2500 Duramax CCSB 4x4 with lift torsion bar keys and with the bars level up, and 35" diameter tires. All stock and a Nelson tune.
Launching 4WD is like fightting with a bull....you have to hold the steering wheel with all you got (wonder if that contributes to the clunk in my steering shaft lol)

But on the 02 turbo truck I have lowering torsion keys, and the torsion bars almost all down. Truck launch straight as an arrow with little to no figth !!! And I have 20" on 295-45 rubbers !

[boosted]

i was thinking about dropping bars and taking stock block outta rear anyways...so you think ill be ok than


and on a side note, i have efi live i had tuned many trucks into the 12s with it. and i can say those trucks even with dropped bars just will not launch good. dmaxstore sells a cognito pitman and idler arm set and billet tierod sleeves thats what i recommend to most people who wanna race or pull. iv seen too many break a tie rod. and if either of you all have efi i can shoot u a tune if your interested. everything from fuel mileage tunes to ones that put 530~ to rear wheels.

[pl4yboy]

You are not a sponsor here. You don't even have the required number of posts to place a for sale ad. You are only going to get into trouble offering your services as such.

[boosted]

did i say anything about selling.

[pl4yboy]

You implied it.