Front mount guys, need input

[jetmech]

like ducky said, just to the right of the crank pulley, there's enough room for a fitting.
we use 3/4" hose for our drain, but i've seen small 3/8" work as well.

I'll be using AN-10 line for the drain.
Thanks everyone for all the good info

[farmtruc]

and we use -3 for the feed line, just an fyi.

suggested: wrap all your hot pipes before installation, maf goes between throttle body and intercooler, don't let meth (if using) drip on the maf after it's done spraying, use good grade8 bolts, we use silicon and no gasket on the t4 mount.
i'll post more if i can recall any other stuff.

[jetmech]

I was planning on reusing the -4 feed line with my 0.065" restrictor from my current rear mount setup. Would that work? Also, I was entertaining the thought of using the MAF as a draw through in front of the turbo - unless it is best to put the MAF between the intercooler and TB. That's where I have the MAF now but was thinking of moving it. Thanks, and please do post those pics.

[farmtruc]

ya, -4 is fine.

keep the maf where it's at, in between.

[blue0453]

Im running -4 with no issues.

[jetmech]

BTW, how big of a turbo can I run with a 3" downpipe?

[farmtruc]

BTW, how big of a turbo can I run with a 3" downpipe?

if the turbo housing has a 3", then that's what it needs.
the bigger ones will have a 4" housing.

[Jamest]

Mine work good no lights never?

[jetmech]

One more things guys, how am I supposed to get the passenger side 02 sensor to reach the turbo manifold? Is there a plug-n-play harness I can use to extend the wire?

[ducky]

One more things guys, how am I supposed to get the passenger side 02 sensor to reach the turbo manifold? Is there a plug-n-play harness I can use to extend the wire?

Just undo it and pull it all the way up. Thats what I did. You can follow it up the pass side all the way to manifold without having to extend the wire.