Very jealous, my 97 is somewhere in NC, I miss that truck ALOT. You can't put a value on a vehicle you have so many memories in, glad you got her back. Looking forward to the build as well.
Very jealous, my 97 is somewhere in NC, I miss that truck ALOT. You can't put a value on a vehicle you have so many memories in, glad you got her back. Looking forward to the build as well.
2001 GMC Sierra SL ECSB - Project
2012 Honda Civic Si - DD
2009 GMC Sierra SLT ECSB - Sold
Time for an update.
L33 is in and bolted up. I'm not to far from backing it out of the garage. Was aiming for 30 days, but going to be more like 45 days.
Enjoy.
1979 C-10 Big 10 LSx powered BUSTED REAR END
1994 K1500 05 L33/60E swapped
2005 Yukon 4x4 factory 4.10's
Lookin good man keep us updated!
Josh ----- 95 Z71 ecss -6.0 swap finished 10k miles ago, nelson tuned, built tranny, 2800 converter, 4.56s truetrac
2000 z28 a4 longtubes, true duals, ported throttle body, ls6 intake, slp lid (lost in divorce lol)
79 camaro small block street car 11.60 @ 116 (sold)
Ran wires to the fuse block from the pump and one from the old coil lead. Still need to run ALDL, and run wires into the cab for the DBW. Jumped a wire from the fuse block to the fire wall power connector on the passengers side and turned the key on, pump primed and shut off! Grabbed the pedal and plugged it all in, and the foot feed works as well. Pretty close to being in business! Just a few more hours of work!!!
1979 C-10 Big 10 LSx powered BUSTED REAR END
1994 K1500 05 L33/60E swapped
2005 Yukon 4x4 factory 4.10's
Have not updated for a while. Snowed in, so plenty of time for the web
Got the 94 up and running about 2 weeks ago. Hands down the best thing I could of done to the truck. The L33 fired off and runs great. I have put about 400 miles on it with no issues. Drove it in the snow some today, and its a beast! Towed the trailer this past saturday and has plenty of towing power.
Here are a few updated pics. Fire away if you have any questions on how I did something.
1979 C-10 Big 10 LSx powered BUSTED REAR END
1994 K1500 05 L33/60E swapped
2005 Yukon 4x4 factory 4.10's
Very clean! Nice work
Looks good!
how did your transmission line up with the driveshafts? I'm about to do a LQ9 in a 1988 k1500 and need transmission advice.
Hey Jake,
It all sure did, has been in the truck running same shafts and U joints in 2011. The 4L60E that is behind LQ9's will bolt up to the late model NP241 cases. Now I'm not to sure what would be behind your 88 Transmission. But parts for early/mid 90's trucks should be plentiful.
Just about to pull it all out and donate the L33/60E to my Tahoe. This old girl is going in for long term restoration.
Plans are
454 EFI
4L80E
Solid axle swap
Remove Body lift
Clean Clean Clean.... and send off for paint at some point.
Last edited by bowtieguy79; 09-27-2017 at 04:09 PM.
1979 C-10 Big 10 LSx powered BUSTED REAR END
1994 K1500 05 L33/60E swapped
2005 Yukon 4x4 factory 4.10's
Posting Permissions
Reply With Quote
