I'm new to this forum and wanted to share my project. I'm in the middle of putting an 05 5.3 w/4L60 into my 75 cj. What has been done; motor and trans are in after; extending the front of the fram to accomidate the SOA YJ spring conversion. Had to do SOA to get the front driveline to clear the pan. I used the Dana 300 short shaft transfer case. Had to move the rear axel back about two inches to get some drive line length and decrease the angel. Aluminum 4 row radiator is in. Air intack is done. Harness is hooked up to the motor, still need to figure out where to mount it in the cab. Dakota Digital guage still needs to be hooked up. Need to finish up exhaust..........to be continued.
Reply With Quote
Originally Posted by Joe3
