+ Reply to Thread
Results 1 to 7 of 7

Thread: red pin 42...

Hybrid View

  1. 09-01-2010 12:13 AM #1
    rammor02
    rammor02 is offline Member
    Join Date
    Oct 2008
    Posts
    54
    i understand that it goes to the tranny but in the sticky it says to bundle the wires and route them in the cab.
    what do you do with it once in the cab..supply power, ign power, ??? ground??? or is it controlled by the ecm?
    I understand all the other wires in the bundle, except this one
    Thanks
    Its been so long since i did my harness in my ECSB that i dont remember...I did my own standalone and its working perfect...just dont remember this wire.
    Last edited by rammor02; 09-01-2010 at 12:18 AM.
    93 ECSB...lq4 6.0 swap, 255 walbro,cai, ported tb, shorty headers, 3" exhaust, tune,electric fans, NX wet kit 100 shot, 2/4 drop, beltech shocks, boss 335 22's, 295/30/22...looking for a cam.
    Reply With Quote Reply With Quote
  2. 09-01-2010 01:12 AM #2
    rammor02
    rammor02 is offline Member
    Join Date
    Oct 2008
    Posts
    54
    alright i looked at the wiring diagram and looks like its controlled by the ecm...and i did run the power to the tranny connector. so am i reading or misunderstanding something on the sticky where this wire is ran into the cab...just want to clarify so i can start installing my guages and wire run the rest of my powers.
    93 ECSB...lq4 6.0 swap, 255 walbro,cai, ported tb, shorty headers, 3" exhaust, tune,electric fans, NX wet kit 100 shot, 2/4 drop, beltech shocks, boss 335 22's, 295/30/22...looking for a cam.
    Reply With Quote Reply With Quote
+ Reply to Thread
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules