84 c10 2wd 5.3 4l60e install

[low84_inchaska]

Well, I have the body work about done, the engine bay all painted up, the motor and tranny dropped in and the interior soundproofed is where i am at. I am going to include some pics of the project up to this point. I am paranoid about the torque converter getting installed correctly so i am going to drop the transmission and redo it.

here are some pics...enjoy.

truck was blue, not here it is in primer...doing body work.




motor when i first got it too where it is now.




engine bay primed with ppg epoxy, painted with epoxy black, and mulsanne blue. ls installed

[low84_inchaska]

Here is the soundproofed cab, i also did under coating on the tunnel and pans underneath the truck.

[low84_inchaska]

got the harness done by current performance and bought the walbro 255 392...what filter is a good filter to run with this pump that will have enough flow? I also got my tune done by jesse bubb

[low84_inchaska]

anybody?

[knickick]

got the harness done by current performance and bought the walbro 255 392...what filter is a good filter to run with this pump that will have enough flow? I also got my tune done by jesse bubb

I think you should try the one like mine. I will post some photos of it soon. Just wait for it.

[playtimeover]

got the harness done by current performance and bought the walbro 255 392...what filter is a good filter to run with this pump that will have enough flow? I also got my tune done by jesse bubb

I suggest that K&N filter would be great. Did you try it?