Anyone running L92 heads on a LQ9

[cjriojas]

4 inch bore is minimum size for L92's to fit. lq9 has a 4"+ bore. lots of ppl run em.

[J.T.]

is the lq4 the same?

[skeet]

Hearing mixed reviews on this set up. I heard it flow good but the larger valve may have clearance issues. Can anyone verify this?

verified no issues if its setup properly

is the lq4 the same?

same bore different pistons

[ratedx]

[QUOTE=skeet;390770]verified no issues if its setup properly

Set up properly...say if I had them milled .030 and a cam like a torquer v3 with say a ls6 head gasket, I think it's a 5 layer someone said, would this be properly done?

[George C]

not a good selection of parts on that one[QUOTE=ratedx;391016]

verified no issues if its setup properly

Set up properly...say if I had them milled .030 and a cam like a torquer v3 with say a ls6 head gasket, I think it's a 5 layer someone said, would this be properly done?

[banker099]

not a good selection of parts on that one

+1
run factory l92/ls3 gaskets, and thats not a good cam for l92s

[Wtfan18]

if im correct the L92 heads intake side flows much more than the exhaust side so the cam must have bais to the exaust side with a longer exhaust duration.