Originally posted by zro26t@Dec 31 2005, 07:03 AM
I'm pretty sure I can graff the NBS engine harness directly into the OBS fuse block. Someone has already done this in Tennessee (Dana Dash did it for a guy who works for Tennessee Auto). I'm planning on using Dakota Digital 73 - 87 cluster kit (electric gauges). They'll have the speedo, tach, oil press, water temp, volts, and fuel gauges.

Questions:

#1 - Is there a need to have the '02 fuse block, or should I just graff the engine harness directly to the '86 fuse block?
#2 - What would it take to make wiring provisions for e-fans?
#3 - If above is possible, how much are your harnesses?

***edit: #3's answer is $550, right? Saw in another post.
IF you're using all electronic gauges, then you'll simply be able to tap into the new LS1 Harness.
I do supply a wire for tach and speedometer, so that's two down. Use the three wire temp for the water gauge. The fuel and volt meter will probably already work.
Sounds like you got it down.
The fuse block I supply isn't needed if you're using the original fuse block. Just find a couple of extra ignition spots, battery and ground it, you're done.
I'd say use the orginal fuse block, you'll probably have extra spots open after you remove the original engine harness.
If you don't want to do that, the fuse block I use is only a 4 bang fuse block, so it's very small and can be hidden or installed anywhere.
Fans: we're actually going to offer that as part of the harness too.
We'd simply add our current harness into the engin harness.
I'll need to know what kind of fans you'll be using and will you be using A/C.

thanks guys,

allen