Did the T56 mount in same place as 5sp? Did you do your own harness? I have a DBW(from 05) and DBC but am not sure which one to use. I do not know if all the DBW will work with any PCM.
Did the T56 mount in same place as 5sp? Did you do your own harness? I have a DBW(from 05) and DBC but am not sure which one to use. I do not know if all the DBW will work with any PCM.
Last edited by Old Nash; 07-27-2010 at 12:53 PM.
The crossmember was used, but had to be relocated in the frame a few inches. The 5.7 LS1 came with a harness, but it was pretty ugly. I have a Nelson harness and programmed ECM.Originally Posted by Old Nash
I measured my drive shaft and it was 61". I found out the 14 bolt also uses a different U joint(1350) and 10 bolt uses a 1310. I understand you can buy a u joint with the two combined to hook the drive shaft to Rear end.
Last edited by Old Nash; 07-28-2010 at 04:17 PM.
Well it took me a while to find my camera but here is a pic of the stock shifter location for comparison to one that has been relocated.
What seats did you use there?
'97 Tahoe bucket seats.
I bet you found the camera in the shoe. lol
Thanks, the picture gives an ideal how far it is back between seats and how McLeod shifter would help. I found a picture of what a guy did to incorporate his 6 sp shifter into the console.
www.akvalley.net/~ss/
Last edited by Old Nash; 08-10-2010 at 03:59 PM.
Posting Permissions
Reply With Quote