LS1 in bagged/bodydropped obs truck?

[rufus39]

i don't think you want to offset the motor back with the BD. I have a 5.3 in my 93 that is bagged/SFBD with the transdapt factory location mounts (4572 i think?) and the schoenfeld LTs. When i did my BD i set the cab back 1/2" to center the front wheels and close some of the gap between the bed and cab. On the passenger side i had to make a small mini-tub for the header as i was shy about 1/2" in one spot. Since your BD is traditional, you may have gained that room depending on where your cut line is.

[ryan350]

ok cool is there a link to the standard mounts? when i type that part number in google it comes up with a fair few different types of engine mounts! also what power steering pump is used on the ls1, the one off my engine or the factory one off the ls1?

[ryan350]

can anyone give a link to the engine mount bracket kit needed please? need to order one asap! cheers ryan

[SimpleGreen]

can anyone give a link to the engine mount bracket kit needed please? need to order one asap! cheers ryan

I ordered these (1" set back). He also sells the non setback version.

http://cgi.ebay.com/ebaymotors/ws/eB...m=280542394863

They haven't shown up yet so I can't vouch for quality or fitment just yet. Guy has good feedback....and how hard could it be to mess up a 5/16" steel plate?

[ryan350]

thanks simple green! have sent the seller a email, he says he does not do international shipping but im hoping he will as i am going to buy a set of 1'' set back ones and a pair of the normal ones.