LS1 in bagged/bodydropped obs truck?

[flattopwill]

Yes you are correct.

[ryan350]

once again thank you very much flattopwill!

[ryan350]

also could someone post a link to the engine mount adaptors please? thanks again ryan

[ryan350]

ok been doing some research and found these adaptors for the engine mounts
http://cgi.ebay.com/ebaymotors/ws/eB...m=280528597041

also found these headers
http://www.schoenfeldheaders.com/LS1-TRUCK.htm

Now can anyone tell me if these mounts will be fine for clearance ect... with the adaptor plates shown, if not can some one send me a link to the adaptors i need, thanks very much ryan also i will be running a auto transmission if that makes any difference

[rufus39]

i don't think you want to offset the motor back with the BD. I have a 5.3 in my 93 that is bagged/SFBD with the transdapt factory location mounts (4572 i think?) and the schoenfeld LTs. When i did my BD i set the cab back 1/2" to center the front wheels and close some of the gap between the bed and cab. On the passenger side i had to make a small mini-tub for the header as i was shy about 1/2" in one spot. Since your BD is traditional, you may have gained that room depending on where your cut line is.

[ryan350]

ok cool is there a link to the standard mounts? when i type that part number in google it comes up with a fair few different types of engine mounts! also what power steering pump is used on the ls1, the one off my engine or the factory one off the ls1?

[ryan350]

can anyone give a link to the engine mount bracket kit needed please? need to order one asap! cheers ryan