+ Reply to Thread
Page 2 of 2 FirstFirst 1 2
Results 11 to 13 of 13

Thread: Question reffering to cam bearings........

  1. 06-21-2010 05:58 PM #11
    CHEVROLADE
    CHEVROLADE is offline Senior Member
    Join Date
    Jan 2008
    Posts
    8,031
    glad u are helping me jon,,,ok one question,these oil gallies are they only on the right side of the engine?like one gallie to each lobe?they did not align the 3rd bearing good all the rest the coat hanger goes through but the 3rd bearing!!i can see right through and that 3rd one is a little off....why dont these damm shops check this kind of shit before they let it go!
    Reply With Quote Reply With Quote
  2. 06-21-2010 06:09 PM #12
    DBRODS's Avatar
    DBRODS
    DBRODS is offline Worlds fastest EC
    Join Date
    May 2008
    Location
    Round Rock, TX
    Posts
    3,069
    No problem... Yes they are only on the Pass side. If the middle one is off that bad then you are going to have serious issues with oiling.. I would get them to fix it before you do anything else.
    Reply With Quote Reply With Quote
  3. 06-21-2010 06:13 PM #13
    CHEVROLADE
    CHEVROLADE is offline Senior Member
    Join Date
    Jan 2008
    Posts
    8,031
    just seen this tool,probably couldve done a better job if this tool aint hard to use

    http://carshop.carshopinc.com/produc.../103019/c/s1-l

    guess back to the machine shop
    Reply With Quote Reply With Quote
+ Reply to Thread
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts

Forum Rules