Gears, Posi's, Lockers, Bearings, Axles, More!

[2boosted]

Dana 46590-10149
REV - M
07-17-98

10 bolt, 32 spline, 3.73 open carrier

At least a powertrax, or any solution

Thanks in advance

[TXSZ66AVLANCHE]

Ron, I roasted the LSD in my 04 Avalanche Z66 this weekend. I am VERY interested in a replacement for it, what would you recomend and do you offer a guide for installation? Thanks! I hear nothing but good stuff about you!

[farmtruc]

i know you're asking ron, but i got the detroit true trac from ron for my 05 avalanche, the construction is nice and rugged looking, like it's strong and machined very well.
has a nice center pin setup.
that and a basic rebuild / install kit should be all you need.

i did the master rebuild kit, but didn't need it.

[TXSZ66AVLANCHE]

i know you're asking ron, but i got the detroit true trac from ron for my 05 avalanche, the construction is nice and rugged looking, like it's strong and machined very well.
has a nice center pin setup.
that and a basic rebuild / install kit should be all you need.

i did the master rebuild kit, but didn't need it.

I had the carrier bearings and pinion bearings replaced last fall, the told me that the LSD needed work but I decided not too. I think it should be good to go with just a new carrier, but I am open to suggestions.

[R0G3R]

How much for some motive 4.10 gears and tru trac or eaton posi?

[RONS MACHINING SERVICE]

How much for some motive 4.10 gears and tru trac or eaton posi?

Hello, we can offer the following package:

1- GM 8.5 4.10 Motive gear
1- GM 8.5 Truetrac
1- GM 8.5 master install kit

Total: $599.99

Thanks!

www.ronsmachiningservice.net

[RONS MACHINING SERVICE]

PM's sent, Thanks!

[Chris092183]

Hey guys what gears do you think I should get? I currently have about 440 rwhp (an estimate with the addition of lt's, deleted cats, true 3" duals and nelson tune to my last dyno run at 356hp/369tq)...it was on a mustang dyno so the 356hp/369tq should've be higher too.

what gears should I run at that power level and with me running 255/75/17 tires they are about 31.6" tall.

Thanks guys

[farmtruc]

Hey guys what gears do you think I should get? I currently have about 440 rwhp (an estimate with the addition of lt's, deleted cats, true 3" duals and nelson tune to my last dyno run at 356hp/369tq)...it was on a mustang dyno so the 356hp/369tq should've be higher too.

what gears should I run at that power level and with me running 255/75/17 tires they are about 31.6" tall.

Thanks guys

i would run a minimum of 4.10's with a 31" tire.

we've done 4.56 gears in the past with 31" tires and they run great!
rpms are still acceptable on the highway.

[fastlt1]

4.56s You will still have room to grow on the strip.