-
Danger is correct about it not throwing your cam timing off to much. .01 isn’t that big of a mill, if memory serves when I milled a toyota 5sfe head .040 it retarded the cam timing somewhere around 3.5 degrees as a + it pushed the power up a couple of 100 rpm on the toyota.
Sorry didn’t know were my head was at but realized after I signed off .01 is a huge mill and using .040 and 3.5 as a guide your cam timing is -8.75 degrees
Last edited by beingblueeyes; 06-13-2010 at 05:12 PM.
Reason: wasent think'in
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Forum Rules
Reply With Quote