East Texas

[Cominup]

How hard is it for people to do what there payed for? But I'll look into rays, What are you supposed to b getting done at kennys

[molitor]

I bought a Burn Victim 6.0L lq4 from a 2003 2500HD. truck burned to the ground, intake manifold melted all over the top. it was nasty to say the least, so a couple of trips to the carwash and two can each of oven cleaner and degreaser, i had the engine pretty clean. took it home disassembled it, found out it needed to be bored out because water had sat in the cylinders and pitted the walls with rust.

So i took it to kennys and this is what i told him to do. Deck the block, line hone the mains and cam journals, vat the block, replace all the bearings and put a good set of forged pistons on the stock rods. he then said he wouldn't warranty the shortblock so i would have to do the assembly myself.

i could understand if it took him a little while to get the work done, but he hasn't even touched it except for dropping it in a vat to clean it.

and every time i call him, he says he'll get to it soon, monday, wednesday, all kinds of excuses. i'm tired of waiting