-
The pump took a dump. I replaced it with a GSS340 walbro. The truck fired up and ran great for two days. It did the same thing today ran out of fuel at higher rpm and now won't start? Any suggestions on why my truck is trashing fuel pumps? Thanks
Rodger
-
Maybe you got a bad pump it happens. Also not sure but is this a pump that you put in your factory canister? If so I would take a close look at that connector they were prone causing problems. They make a updated pigtail that I like to solder on, but connectors can corrode so if you have a updated connector that is put on with but connectors I would look there too. Don't forget the relay, if there is a problem with your system its do to a voltage drop caused by a bad connection.
BB
-
It is the one you drop in the canister I got the kit from Nelson. I also used there new connector. I will check the relay today. Could the relay cause the pump to go bad? I installed it Saturday I used solder and heat shrink for the new connector. If it was the relay why would it work at all just by installing a new pump?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Forum Rules
Reply With Quote