You can find the LS1-6 injectors for around 50 bucks or so. You can find a injector plug here. You will need 8, the link is for a single plug.CEI - Casper's Electronics, Inc.
On the spacers, don't waste your money. Go to Ace or any hardware store and find a bolt that fits where the stock bolt goes through the rail and into the intake. Get 3 nuts for each bolt. For a total of 4 bolts and 12 nuts. To space the fuel rail put one nut on the bolt, then stick the bolt through the mount hole on the fuel rail, then put the other two nuts on the bolt. Do this to all four mount holes. When your done with this screw the bolts into the mounting holes on the intake. After the bolts are in screw the nut on the bottom down to the intake and use as a set nut to keep the bolt from backing out. Now use the other two bolts to adjust the height of the rail itself. Use the middle bolt to set the height and the bolt on top to hold the rail down. Used this on my truck, I am running the LS6 injectors out of a Vette. The bolts and nuts run around 6 or 7 bucks if I remember.
Reply With Quote