Ackattack's Pro touring restoration thread - The 1947 - Present Chevrolet & GMC Truck Message Board Network here is a link on a build im going off of the headers i got are pretty much the same design as these and i just got em yesterday they look great. and they are not cheap and light weight like some china ones they are 16 gauge with 3/8 flanges that are straight i checked. justin is great to work with and takes care of you well worth the 250.00 if you get a set tell him rob sent ya. the drive side collector does kick out just like on this link but it looks to me like it will work you can always cut some off but i think instead ill take a 3" 45* and cut it down the ceter and weld it on the end I would like to keep the length of the collector for performance reasons