where quality KY at?
where quality KY at?
Blessed be the Lord my strength which teacheth my hands to war, and my fingers to fight:
Psalms 144:1
Si vis pacem, para bellum
45 Miles west of Bowling Green. Just west of a little town called Morgantown in Butler county.
Found that but witch plug???Originally Posted by WARLOCK
You are up there were I will get my drive shaft done. "GLASGOW"
This might help too. These guys have the 4L60E to 4L80E wiring harness adapter. The web page is LONG but its on there.
4L60E Performance Transmissions from PATC
~ Forged engine of some type ~ Ball bearing turbo of an unconfirmed size ~ 4L8000 trans ~ Beefy fuel system ~
Its the top one
2000 Silverado ECSB- 5.3 CAI, Pacesetter LTs, ORY- Pipe, Magnaflow XL, E-fan, Ported T/B , Nelson Tuned, Built 4l60e, Circle D Stall, 3.42s G80, 2-4 Drop, Hertz Highs, Rockford 501s
2004 Buell XB12s
Nelson Performance sells the wiring cheaper than PACT
2004 Buell XB12s
There are posts on how to modify your 60e PCM to work with the 80e transmission. You can also reuse the unused 60e wires to carry the speedometer signal to the PCM, just have to move the wires around on the PCM end and splice the ISS connector into the unused wires at the trans end.
Using the adapter is easy and adding the new ISS sensor wires to the PCM isn't very hard, either.
See my truck data in the "My Garage" section here... http://www.ls1truck.com/forums/my-ga...tml#post191709
5.3 ready to go in. Putting the truck in the shop tonight. Thinking would it be worth the time to buy all new sensors and put them in or not. Also scenes this is going to be a Blower Motor worth the time to put in a cam. The truck will only be street driven and pull a 24 foot enclose.
Toss a z06 cam in it. Very FI friendly
2004 Buell XB12s
Posting Permissions
Reply With Quote
