I have some 4x4 parts I wanna sell. Dana 44 with auburn posi and richmond 4.56's new 6 lug rotors. All new never been used. Also a NP205 from a blazer, standard t-case with th350. New Advance Adapter spacer plate for 700r4. PM me if your in nor cal and are interested.
9.5" of lift and 33" tire land..... bbboooooooo
2009 CHEVROLET 1500 with a MONSTER 4.8 between the frame rails!!
Tuned by LSX Powersports ~ 4.10 ~ JBA Shorties ~ 4" Inlet/Outlet Spintech ~ Airaid Coldair
CST 3.5" Spindles ~ Camburg Upper Control Arms ~ 2.5" CCM ~ FFR Tie Rods
Full Throttle Suspension 3" Lift Blocks ~ Soft 8s wrapped in LT285/70/17 Silent Armors
Probably have better luck in the FS section if you have pictures.
1969 Chevy RCLB C10 350/TH400 SOLD
2007 Chevy RCSB 4.8 4x4 LS SOLD
2008 Chevy RCSB 5.3 4x4 LT SOLD
2010 Chevy CCSB 6.2 4x4 LT SOLD
2005 GMC CCLB DRW 6.6 Duramax 4x4 191,000 and counting
2013 FORD CCSB F350 6.7 Powerstroke 4x4
That's more like Bakersfield/Fresno, up here (Sacramento) it's a little more normal. And a lot more rock crawlers being so close to the rubicon. Ya just figured I would grab more attention for parts like these in this section. Lookin for local dealings.Originally Posted by small1town9kid
Chevy 44 or a Ford 44?
1992 ECSB SFA K1500: D60 Front, D70 Rear, Hydro assist. 9"s of lift sittin' on 37"s
1997 RCSB K1500: CAI, Exhaust, Tune. Headed to the trans shop!
1999 2dr Tahoe: 4" Rancho Lift, 4.56s W/ True-trac.
Chevy. From a 75 Blazer. Its ready to go.
Posting Permissions
Reply With Quote