ok everyone. im replacing the water pump in my 03 SSS
I was checking out the situation before hand and noticed this
its at the top of the water pump, right under the TB.
Now, on my replacement pump, I do not have such a hole..
can anyone advise?
ok everyone. im replacing the water pump in my 03 SSS
I was checking out the situation before hand and noticed this
its at the top of the water pump, right under the TB.
Now, on my replacement pump, I do not have such a hole..
can anyone advise?
Sponsored by Taylor Wires!
Sponsored by PowerMaster!!
Sponsored by FROZEN BOOST!
Sponsored by US Speedo!
mike are you talking about that ''gap''?
Generally that kind of thing can change when it is a cast part, because engineers are always looking to make the casting and casting process more efficient. If it does not fit then it would be a problem, but i think that the replacement water pump manufacturer found a better way to make the casting, plus with continuous shapes they are much stronger than castings with pointed or sharp edges.
1999 GMC Sierra SLE ECSB .... 5.3L w/ Slight Performance Tune / True Duals with Flo Pro Glass Packs.
Project ''Bad Company'' Future = 6.0L (Forged Internals) / Boost (TVS) / 4L65E LvL 5 / AWD Conversion / Full LT's with Cats / Methanol Injection / Lowered 2" / SS Rims / Frame Up resto
Officially Employed!!!
no i was talking about that bolt that faces backward.. turns out its a plate that covers the impeller.. new pumps dont have that.. i got the job done.
Sponsored by Taylor Wires!
Sponsored by PowerMaster!!
Sponsored by FROZEN BOOST!
Sponsored by US Speedo!
Posting Permissions
Reply With Quote