Edge converters?

[musky02]

Been thinking about getting an Edge stall for my 4l80,was wondering if anyone has had any issues with them,or if i should get a different brand?

[kbracing96]

I had one, will say this about the company, possibly the best customer service I have ever had. Unfortunately for some reason the stall he built for me didn't stall near what it was supposed too. I wanted a tight 3000 converter and the one I got I could foot brake to 4000 and 10 psi of boost. I called him about it, he said he had never had one do that before and didn't know what the deal could be. He though there was a slight possibility the he put the wrong turbine in it, cus he said there was no way that if it had what he though it should've had that I could have ever get that much stall out of it. I drove it like that for a couple months till I finally decided to just buy a Circle D. I told Andra I was just gonna sell his stall and buy another he said there was no need to sell it, he had a 100% satisfaction guaranty and for me to send it back and he would give me a full refund. He would have also built me a new stall I could have swapped in exchange, but I opted for the heaver duty Circle D. Sent him back the stall and he sent me back a full refund. Like I said, TOP NOTCH CS! If I was building a lower HP setup, I wouldn't hesitate to use one of his converters again.

[musky02]

Well i am looking for a converter for a 450-500 horse motor. How much are circle D's?

[kbracing96]

Well i am looking for a converter for a 450-500 horse motor. How much are circle D's?

Their multi disk is around $1100 and there single is around $800 I think.

[SRT10KLLR]

I went with an Edge because he was one of the first to build them for the Hemi's and so I thought I would also use it on the Silverado. So far so good as I have had it for over a year with no problems. I am currently only doing 300 rwhp but after the turbo I am hoping for +500 rwhp. My stall is at 2600 right now. His converters are more reasonably priced than the others.