Anyone have the JPR cam install tool? or The valve spring tools?
Anyone have the JPR cam install tool? or The valve spring tools?
2000 Silverado ECSB- 5.3 CAI, Pacesetter LTs, ORY- Pipe, Magnaflow XL, E-fan, Ported T/B , Nelson Tuned, Built 4l60e, Circle D Stall, 3.42s G80, 2-4 Drop, Hertz Highs, Rockford 501s
2004 Buell XB12s
Originally Posted by LamboDoNoMo
I have a crane cams valve spring compressor
~ Forged engine of some type ~ Ball bearing turbo of an unconfirmed size ~ 4L8000 trans ~ Beefy fuel system ~
Willing to rent it when the time comes?
2004 Buell XB12s
Who's got the pass it around tool? I know Mark had it and shipped it elsewhere but then what?
I was wondering that myself. What you you use at the dealership to keep the lifters up?
2004 Buell XB12s
Sure, I'll rent it out whenever. I used it once and I've been trying to sell it ever since. Works great though
~ Forged engine of some type ~ Ball bearing turbo of an unconfirmed size ~ 4L8000 trans ~ Beefy fuel system ~
Pm sent
2004 Buell XB12s
to hold the lifters up just go to advance or autozone and buy a 48" piece of 5/16 steel brake line cut to 21" pieces out of it. thats what I did and it worked great and only cost like 10 bucks
Master power t-76 kbracing, Intercooled, 11psi, tr220 cam, patriot dual springs, 72lbrs, snow meth, walbro, efans, 80e, tansgo, yank 3200.
Ive heard of dowel rods too. I take it there are just 2 holes in the block for the tools to go into? IVe never done a cam swap on one of these..
2004 Buell XB12s
yeah just lube the rods and they slide right in to hold lifters up
Posting Permissions
Reply With Quote
