thanks guys for the welcomes and comments.Originally Posted by 408.Luke
Sounds like a good group glad to have yalldo you have a cam in the red truck to? and plan on any spray?
yes,we put a lingenfelter cam for n2o and i do want to spray a 125 or 150. this 6.0 HAD a big cam with big lift when we got the motor and the pistons were fly cut which in my opinion sxxx. we are planning to forge this motor due to the fly cut and put some good pistons and rings for nos.
Last edited by Gladiator 6.0; 04-19-2009 at 01:54 AM.
gald to have yall aboard, this is a good site. Its awesome to see young people getting so deep in performance so early. keep us posted on your progress.
single digit street truck
for build info
http://www.ls1truck.com/forums/my-ga...cs-garage.html
The best advice I have ever heard:... Only take B( . Y . )ST advice from someone that is CURRENTLY running a turbo setup close to, or bigger than what you want......
Welcome to the site!
2006 extended cab, 6.0 swap, full bolt ons SOLD
2011 ECSB, 6.2, 6 spd, 3.73, 5" lift, 33" nitto, limo tint, debadged, volant CAI, muffler delete, black bear tune 14.0 @ 98 on the 33'sSOLD
2007 TBSS AWD, cam, stall, built trans, N2OSOLD
2006 RCSB cammed LQ9, full exhaust, 3200 stall, 2-4 drop
49 Ford F1
355 chevy / turbo 350 / 12 bolt posi / camaro subframed
Welcome Saul!
dammmmnnnit... crazy 2nd truck.. i barely driving my first truck... LOL
Enjoy your stay!
Her name is A Meli-
"If everything is under control, you are going too slow."- MA
Welcome..
2000 sil.ext. 5.3 / Lingenfelter Ls1 cam / LS1 valves / Ported / Milled / 35lb injectors / 80mm tb / E-fans / cold air intake / Pacesetter Cer LT's w/3"ory/ JET-DST / MSD Twister / Corvette Servo / 3.73's / 125 N2O / no cats / Flowmaster exhaust / level rear drop / Rear sway bar / SS wheels / 285/50R20 Goodyears / 05 Tail lites
Sup Mr Oil spills Saul lol your trucks look awesome
thanks, we will get some trackgald to have yall aboard, this is a good site. Its awesome to see young people getting so deep in performance so early. keep us posted on your progress.
#s then take pictures of the fly cut pistons when they are comming out.
thanks guys and gals for the welcomes.
Posting Permissions
Reply With Quote
