2007 5.3 Into 1948 Chevy 5 Window Pickup

[sandking]

I was referring to the flange at the manifold. On my last build, I used shorty headers on my LS1. When I had the exhaust built, they did not have the perticulay flange on hand. So I opted to cut it off and weld on a more common flange. I will see if I can dig up some pics..........

[AB6DO]

The center dump Camaro manifolds are close to the frame rails but there is enough room for the exhaust pipe with having to trim the frame.

The Camaro exhaust manifolds are cast iron, not that easy to cut and weld.

The exhaust manifolds have outlets for 2 bolt tail pipe flange. The two bolt flange that bolts the tail pipe to the exhaust manifold is what I am looking for.

I am going to run true dual exhaust with no cat convertors.