Here is my setup. I dont remember the exact total but I damn sure dont have anywhere near a grand in it. Its just a billet overlay with the same gauges you are showing. I know what you mean about the gauges pointing a little downwards. It gets annoying sometimes. Autometer has some rings that help point them upwards a little but I dont know how good they will look with the black plastic showing between the ring on the gauge and the insert.
00' Ls1, TSP 228R - 228/228 .588/.588, Yank SST3200, Nelson tune, Nelson wiring harness,
s&p headers, custom radiator with e-fans,91 sub front end with billet grill and bowtie,autometer gauges, red and grey tweed interior, dual 2.5" flowmaster super 40, Dmh cut outs, 5"-7" drop,air shocks, 20" Intro twisted vistas, gaylords bed cover
Coming soon: Air ride with an SD raised front crossmember and 6 link canti out back
The problem with using angled gauge bezels is they require every gauge hole to be enlarged, are a larger diameter than the gauges rims causing crowding & coverage of your nice billet panel engraved lines, etc. Is there any way to recess your entire exsisting panels deeper into the dash & angleing them back at the same time?
Posting Permissions
Reply With Quote