+ Reply to Thread
Page 2 of 2 FirstFirst 1 2
Results 11 to 13 of 13

Thread: Got cam installed!

  1. #11
    Join Date
    Dec 2003
    Posts
    72
    Why are you shifting at 5100? I shift a lot higher than that 5800 minimum.
    How high can you set your rev limiter?
    TnTrk53 grn '01 ecsb.
    a lot of bolt-ons and a bolt-in
    Tailgate shown daily

  2. #12
    Join Date
    Apr 2003
    Location
    South MS
    Posts
    129
    I have the 0968 in mine and have noticed all the same things you have. Mine definately picked up over 4k though. Mine used to really fall off over 5500 or so but now it pulls all the way to my 6100 shift point.
    2000 Silverado, RCSB, 2wd w/ a few mods.
    Best 1/4 ET: 12.09@111.22 (old 5.3L H/C/N2O setup)
    WRE 370 and Kenne Bell 2.8L installed and breaking trannys.


    2001 Tahoe LT 4wd
    Stock, daily driver and tow vehicle.


  3. #13
    Join Date
    May 2004
    Posts
    658
    Originally posted by TnTrk53@Jun 8 2004, 08:15 PM
    Why are you shifting at 5100? I shift a lot higher than that 5800 minimum.
    How high can you set your rev limiter?
    Truck was basically stock. No PCM work until this past Fri. Drove up to San Antone and got tune installed, she now shifts at 5800 and pulls from 3k on up! Doesn't shift out of 2nd till about 90, stock was 80. Had fun talking to Joe and Allen, but I think my brother and his brother-in-law had more fun,especially on the way home. Lets just say I'll have to post in the kills section....Zed
    13.920 @ 98.94mph...[/b]

+ Reply to Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts