I need misc bends and couplers. I need that piece that you ahve welded with a 45 on teh firewall end and the(looks like) 90 by the core support. The part that goes form where the MAF would be if I was running on to the bend that sends the piping down to the inlet of I/C. Thats the only one I think I would need welded. If there are any others you can think of that I can just get you to weld to minimize couplers Im open to suggestions. Does it make it alot easier to route the piping with efans? I just need to buy some LS1 efans to throw on there.