I have checked the pins 4 times. I didn't label each wire when I repinned, but I did go one by one. Looking at the spreadsheet, all the wires are the correct color and in the correct location. The unused locations all match. On the black box, I had a blk/wht jumper wire, which I believe connected the C3-18 & C4-12 blackbox locations. My sprdsheet puts C3-18 at C2-1 on the 0411 (red connector). It has C4-12 going to C2-40, but says not all 96 trucks have the wire. Both the C2-1 & C2-40 locations are grounds, so I spliced both of them into the C1-1 location on the blue connector.

Per the sprdsheet, I'm showing to have Ignition Feed (12v switched) at 0411 locations C1-19 & C1-75. When I turn the key to run/on position, I get power (test light) at C1-19. I don't have power at C1-75 with ignition in run/on position. Last, sprdsheet says to tape a pink wire for blackbox C1-4 back into the harness. Says this is an ignition feed for charcoal canister from 1998 truck. This wire has power when I put key in run/on position.

Seems like I may have an issue with C1-75 not getting ignition feed. Am I on to something here ?

Thanks,
Mike