Max lift how aggressive the lift milling and more is going to Effect PTV issues. I wouldn't be surprised if it became an issue at 600ish lift flattops and milled heads. You may need to fly cut piston reliefs or go will a lower lift cam. In order to be in the power at 3000 rpm I would imagine you would need to keep the duration below 224. However, utilizing a good split will sacrifice peak power for a wider power band. A 222/226 .591/.598 LSA111+3 would be a fantastic cam matched to a 2800 stall. Lots of mash able power and the compression will keep the torque strong out of the gate. There is no magic combo however about 11:1 compression with everything else should make for a very fun setup. I could see a setup like this producing over 400@the flywheel.