I got an 2000 LQ4 goin' in to a 1996 Tahoe 4x4. Can anyone tell me what wires I have to keep from the engine harness to C100 and where they go??? I have gotten most of them as I figure, but I would like to be sure of what goes where.
I also have an issue with my starter. My Tahoe is the type with the tailgate, and after I got most of my harness together I tried to open my tailgate. Well instead of tripping the relay for the glass it tripped the starter. I traced back every wire that connected from the starter relay to make sure they were all connected to the correct wires and terminals. And I far as know their all correct, but whether the ignition is on or off the starter still trips from the tailgate button!!! I have no idea where I may have f'ed up with the harness but this kinda boggles my mind.
By no means am I new at wiring but this all is somewhat overwhelming and I'd like to know if I'm wrong before I try to start this new motor. A few other wiring ?'s what do i need to connect to run my four wheel drive and ABS if possible? I basically want this thing to run like it was supposed to be there. I got everything when I bought the engine: harness, PCM, sensors, accessories, etc. So I'd like to run the new PCM with the stock gauges and like I said just make it like it was supposed to be there.
As a note I'm only runnig the 60e right now cuz of cost of the 80e swap but I will end up there eventually hopefully with AWD too.

Can someone please help me with these issues I am having??? Please???