people with tbss intakes come on in (87mm tb wiring)

[beingblueeyes]

i installed my tbss intake today and it went on with out an problems, but when i went to re-wire the truck 8 pin tb plug to the 6 pin 87mm tb that's when i steeped into poop. here's how i wired it:
[IMG][/IMG]
the 2 wires left out are
gry: 5 volt ref
blk: low ref

it will idle fine @ 600-700rpm and rev in park ( revd to 3000rpm and almost staled out when it came back down) with out setting any codes but 1.5 miles into 3 mile "test track" the check motor light came on and it went into reduced power mode after pulling the codes they are
P2101 - Throttle actuator control module range
P0120 - throttle/pedal position sensor switch A and switch B malfunction
P0220 - ^^^
P1516 - Throttle Actuator Control (TAC) Module Throttle Actuator Position Performance

pertinent info:
the tune has not been touched after i installed manifold/tb
did not use x link used different tac module (12574221)

so im thinking when i re-wired it i wired the 2 tps signal wires backwards. any other ideas?