5.3 in an 89 suburban, motor mount/crossmember/exh manifold clearance??

[muddysub]

hey, obviously i'm new here, i was referred by some guys on CK5.com. i tried doing some searching last night but didnt really come up with what i needed. i'm putting a 5.3L into my old TBI suburban. the wiring and won't be a problem, i'm just looking to see if anyone makes an engine crossmember/mounts etc. that'll mount that engine up in my truck or if i'm gonna have to build it myself. from what ive heard the exh manifolds and a/c compressor might be a problem. if anyone has any links or part numbers that might point me in the right direction i'd greatly appreciate it.

this is where the engine is coming from.
http://pirate4x4.com/forum/showthread.php?t=1012735

this is what it's going into.
http://coloradok5.com/forums/showthread.php?t=287329

[Chevy-Art]

Welcome to the site. You should be able to use your factory trans crossmember with no problem. Look for these mounts www.dirtydingo.com I used the carshopinc mounts and they are doing good. For the a/c you will have to notch the frame a little bit, not sure how much though and you should not have any problems with the exhaust manifolds.

[Old Nash]

Lets you use the original compressor and mounts in the same top position that came on 89 Surb.

Novak Brackets. They sell just bracket or whole kit.
http://www.novak-adapt.com/catalog/a...cation_kit.htm

Josh Powers Brackets
http://www.customimagecorvettes.com/?page_id=18